Posted by Gauger on October 14, 2007 at 14:10:21 from (70.92.157.61):
I buttoned up the front end on the SH engine rebuild today. I tripled checked everything (I thought) before installing the heavy cast iron cover. I discovered that I forgot the protective screen for the oil fill. It is the version that is fastened to the inside of the cover with two 1/4" capscrews secured with a safety wire. No problem. I could install it through the opening for the hydraulic pump. Put one screw in, dropped the second and it fell down into the gear train. I wasn't smart enough to flip the engine on the stand so that if I dropped a screw it would simply fall out of the oil fill opening. I could rotate the crank one way only, the screw would jam in between two gears the other way. I played with it for two hours, spinning the engine on the stand and shaking things every which way. No luck. I was just about to give up and get ready for church, destined to pull the cover later, no doubt trashing the gasket, when I gave the crank pulley one last wiggle. Tink! What a great sound. It fell right out. Divine intervention?? :-)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.