Posted by D Slater on October 03, 2007 at 18:01:10 from (72.65.147.160):
In Reply to: RE DISTRIBUTOR IH posted by JAMES T DUNCAN on October 03, 2007 at 13:14:11:
Thats a distributor housing # thats used on letter series and later, very common. The distributor code and # are located on the outside of mounting flange where the 2 clamps go that you losen to adjust timing. Should be able to find a distributor or used parts easy. If you get another shaft, check the # stamped on rotor part to see if it matches yours. If not the total advance will be different. If no match make the replacement shaft advance limit hole the same by enlarging if smaller or filling hole and resize if larger, or carfuly drilling the correct size hole 180 degrees from original hole. The 32 teeth gear is common also.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.