Posted by jal-SD on October 02, 2007 at 06:19:05 from (71.32.32.172):
In Reply to: 1943 farmall H posted by dan160 on October 02, 2007 at 03:56:59:
No easy way to remove radiator. (IMHO, removing the radiator on an H is probably the most miserable job there is when restoring a Farmall.) You have to go up through the bottom of the bolster to get at the two bolts that hold the radiator on at the bottom, can't get in there with a socket, takes a wrench & you have to turn it over with each turn. (I've never tried a ratchet wrench, that MIGHT work better.) They are fine threaded & usually rusted. Be sure to get all the cotter pin out. Don't let them turn in the radiator, they'll break the solder on the bottom of the tank. Best luck I've had is to use lots of PB or your favorite penetrating oil for a couple of days before you start on the nuts. Oh, by the way, you can't see what you are doing very well either. An M isn't much better. Also, getting the height right for the steering shaft to go through the top tank when you put it back on is real a pain. (My $0.02 worth. jal-SD)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.