Posted by Janicholson on September 30, 2007 at 08:53:46 from (66.173.50.140):
In Reply to: 1066 ih wheel wobble posted by sam riccelli on September 29, 2007 at 20:59:06:
There may be directions in the manual, but here ismy method. Jack up the wheel to just clear the ground and block it well (do not use the jack for support) Place a cinder block close to the outside of the wheel and use a c-clamp to attach a piece of 1/8" welding rod to the block so that it just points to the very edge of the rim (where the tire bead is visible) Rotate the tire(by hand, not with the engine), with the differential lock off if it has one. Observe the relationship between the rim and the tip of the Welding rod the total runout will need to be less than 1/8" if you are going to be happy at all at high speeds. Adjust as needed with the wedges. If the rim seems pretty straight, the tire may have a set in the cords and carcase that may never come out. (a flat spot). Good luck, JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
