Posted by Gearnut on September 28, 2007 at 17:58:02 from (68.40.55.114):
Gentleman...
I was at a pull a few weeks ago talking with a man who currently runs a V8 Nostalgia tractor (M with a V8). Prior to this, and for the last 30+ years, he has pulled many tractors including but not limited to IH"s with supercharged 301"s with superchargers. He even pulled with NTPA for a few years chasing points. I"m giving you this information because what I"m about to tell you came from this man"s mouth during a conversation we were having over 301"s.
He said the cylinder bore "thickness" is much thicker on a 301 and if I want to see for myself, he told me to pull a freeze plug out of a 301 and compare it with a 263 or 291. He said the outer wall (where the water touches) will be much closer to the outside of the block on a 301. He said you can put your finger in the freeze plug hole and tell the difference.
I find this absolutely amazing. And if I didn"t hear this from a man who has personally built many of these engines, and blown up quite a few, I would dismiss it as sheer nonsense.
My understanding has always been a 301 runs the piston right on the bore and sleeves are used to sleeve down to a 291, 282, 263, etc. So why on earth would the cyl wall be thicker on a 301 than a 291 or 263? .. or did they do it so they could be bored over a few times ?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
