Posted by ScottyHOMEy on September 28, 2007 at 16:31:21 from (71.241.214.74):
In Reply to: 1941 Farmall A engine posted by Toby Maxwell on September 28, 2007 at 13:51:30:
Toby, the best time to have replaces the pilot bushing would have been while the tractor was spit for the clutch.
In any event eplacing it now would not involve replacing the block. It's centered up in the enrar end of the crank.
I agree with the others that the epoxy patch for the old crack (lemme guess, it's behind the carburetor) will hold. The A, unless it's been modified, is a non-pressurized cooling system, so there's no fluid pressure to speak of on that repair, though there will be some lateral stresses on the epoxy bond from the iron expanding and contracting at a different rate than the patch. That said, many of those repairs were made and have been holding water and anti-freeze for years.
I vote for keeping your block and getting that pilot bushing taken care of.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
