Posted by Red Dave on September 28, 2007 at 15:20:01 from (68.44.136.10):
In Reply to: 1941 Farmall A engine posted by Toby Maxwell on September 28, 2007 at 13:51:30:
I don't understand "We had the clutch replaced about six months ago and the tech working on it told us that the pilot bushing hole is egg shaped. This causes clutch to not operate properly now."
Why on earth would any decent mechanic not replace the pilot bearing when he replaces the clutch? Especially since he noticed that it was worn? I would not be happy about that clutch job, because it wasn't done right.
There are many, many Farmall A, AV, B, BN, C & Super C blocks out there working every day that have had freezing damage and been repaired. On many, you couldn't tell unless you grind off the paint and see the repair. You may even buy a used block and find out that it too has been repaired.
That original block has a serial number that matches the tractor serial number. No replacement block will have that. I would repair it, or have it repaired. It will outlast all of us and then some. And you will have Grandpa's complete tractor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.