Butch, there's no more protection for your valves in 93 octane than there is with 87... and an engine with a compression ratio as low as that 221 certainly doesn't need the octane. If your valves have no hard seats, then you can use a lead substitute additive (available at any auto parts store) to prevent valve seat recession. If you aren't really working the tractor hard, the damage would be so little as to be negligable. A study was done years ago when cars were weaned off leaded fuel and it was found that only high performance cars that were run hard and trucks that were worked hard was valve seat recession a major issue. As I recall, on the more easily worked rigs, it dropped about 10-15 percent off normal life off the valves. When worked hard, it could be from 40-60 percent. If yours is a parade tractor or an occasion field toy, it could take a long time for you to have any problems. Maybe beyond your lifetime. In any case, the protection-in-a-bottle is easily available and inexpensive.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.