Posted by Haas on September 14, 2007 at 13:54:39 from (12.65.78.83):
In Reply to: Belt pully seals posted by jjamna on September 13, 2007 at 19:36:48:
You may need to use a shop press and bearing separator to remove the gear and bearings from the pulley shaft. You may be able to drive them off, but I took the assembly to a shop and had them pressed off and back on. There is not a gasket on the flange that mounts the assembly to the housing. There are shims there to set the gear lash. Be sure you put the shims back like they came out and clean them and the mounting surfaces. Make sure they are absolutely clean when you reassemble but even then, you may have some seepage of gear oil due to there being no gasket, only metal shims. When it's back together, put a pint of gear oil in the fill hole on the belt pulley housing. The transmission lubes the belt pulley bearings, but it takes a while for the oil to sling up there, so you need to add some for initial lube. Oil circulates from the transmission to the belt pulley housing and overflows back to the transmission.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.