Posted by georgeky on September 10, 2007 at 13:24:35 from (64.12.116.73):
In Reply to: C and hydrolic pump posted by Johnny D on September 10, 2007 at 13:07:50:
Johnny, there is a seal in the front of the pump that is bad. The shaft may also be worn and need a speedy sleeve put on it. Use only sae 30 weight oil in the hydraulic system until you get this fixed. Hydraulic oil is to thin for the engine. Seal and gasket kits are available from IH. There are 3 different pumps it could be so you need the part number from pump when ordering kit. The lift unit itself has a kit available for it as well. Keep it clean and lay all parts out in order they come out. Makes putting back together a lot easier. Get an IT No IH-8 service manual as it will be needed for proper adjustment of the lift unit. Not real hard to do, but cleanliness and proper adjustments are critical. Call Brad Marshall and he will send the parts you need right to you. 1-888-824-0544.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.