Posted by ScottyHOMEy on September 05, 2007 at 18:36:42 from (71.241.196.242):
In Reply to: Farmall B-oil and water posted by Dave H (MI) on September 05, 2007 at 17:44:55:
Ah-hah! One culprit found. That baby's been dry for a while.
It wouldn't really do much to reduce humidity in the in crank case, but the rust is a sign of neglect.
To take care of a lot of rust (and especially the kind of rust that is in the "fleece" on that breather cap) I use a product that I found at Home Depot. The brand is Jayco, comes in a cylindrical quart plastic bottle, contents light green in color and can be found in the paint section.
It is a dilute phosphoric acid. The idea is that the acid reacts with the iron oxide and converts it to iron phosphate, which is less susceptible to rust in the presence of moisture. Kind of like the concept of bluing on a gun barrel -- already rusted, just not to make that nasty red iron oxide, and resistant to rusting any further.
You could probably get by with just filling that cap with oil and letting it drain, and the oil left will do the job as the whole thing was designed to do, perhaps even better by virtue of the increased surafce area resulting from the pits!
For small bucks, I'd blow it out with an aerosol solvent like brake cleaner to get rid of whatever crud it has already caught, put the phosphate to it, rinse it out with water, and let it dry before filling it with oil and letting it drain and reinstalling. You could easily skip the acid part and be just fine --use a solvent to clean it out, bathe it in oil and let that oil drain out.
It works a lot like the updraft section of the oil bath air cleaner in that the oil in the "wool" of it traps any dust that might try to pass by.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
