Posted by Jake Winn on September 03, 2007 at 21:00:46 from (207.200.116.7):
Hello everyone. I replaced the contstant mesh gear and input shaft on my 52 H this weekend with a new set from A&I. My old ones had some chipped teeth and were pretty badly pitted. Along with the gears, all the bearings in the transmission were replaced. When I got it assembled, I rotated it over by hand and found that they did not mesh the best and created a bit of noise. Nothing to bad i figured for aftermarket, new gears. I got it assembled enought to run and oil in the transmission/diff and fired it up. It sounded TERRIBLE!!!!. IN fact I think it even had a bit of a vibration to it. It appears that the teeth from the input shaft are riding to deep in the constant mesh gear. Has anyone had this problem with replacement gears? Anyone have a good set of used to sell? Thanks for any help. Jake
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.