Posted by Hugh MacKay on September 02, 2007 at 04:15:03 from (216.208.58.114):
In Reply to: Re: Weight of an MD posted by Doug N on September 02, 2007 at 03:05:41:
Doug: 3" wider and probably close to 3" larger diameter, very likely puts close to twice the rubber surface on the ground. It will not make a whole lot of difference on roadways and other hard surfaces, however in the field situation it make a huge difference.
I learned this one many years ago, IH dealer delivered me a new 1066 with 20.8x38 single wheels and full of calcium chloride. After a season I drained the chloride and added duals. On the field, summer working conditions, it was far superior on drawbar pull in the field, to the singles with chloride. I will tell you this, I had one of the most merry rides of my life on hard frozen ground pulling a 12 tom manure spreader with those duals. Took the duals off, close to doubled the pounds per square inch, got along fine on hard frozen ground.
I had never been happy with my 560 or 656 with 15.5x38 with chloride, just never had the traction or flotation I figured they should have in the field. After the 1066 experience, I installed new 16.9x38 on 560 and 656 and didn't replace the chloride. It made field tractors of both in my opinion. I did keep the chloride and wheel weights on my Farmall 300 with 13.6x38 as it was mainly hauling wagons to barn on hard roads, and did need the weight. In fact as equiped I suspect my 300 was close in weight to 560 and 656. No question, match the tire equipment to the work being performed, it will surprise you how well any tractor performs.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
