Farmall & IHC Tractors Discussion Board |
Re: Re: Knocking sleeves in
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by jakee on February 15, 2000 at 18:47:34 from (152.163.207.52):
In Reply to: Re: Knocking sleeves in posted by The Red on February 14, 2000 at 08:12:50:
bill (per)the IH blue ribon shop book super clean the bore in the block and the out side of sleve then coat out side of sleve with green lock tite,sparingly. wen you fit them they should drop in arond 4 inches then get tite press in the rest of the way.most pepole dont have a press so i use the cookie that i used to pull it with,that way the driving force will distributed at all 360 degrese.you will hear wen it is seated by the diffrent sound wen you strike it,if you cant get the sleve started at the top hone the cylinder some but be careful no to go to far if they fit only hand tite all the way down, you stand the chance of them coming out and wen they do they go strait to the oil pan in a milloin pices.clean the groves at the top real good to make sure they fit all the way. good luck i was worried on my first set and now i have done hundreds of them and only had one go to the oil pan,and it was on a 8-n ford.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|