well...it shows your valves are open! the ATF is running back down and out through the intake...no biggie, just keep adding...watch and see if it runs out when you pour in a certain cylinder...if it runs out immediately....that piston is at TDC or close and the intake valve is open...move to the next one and add more...it shouldn't run out so soon. Nothing is wrong so to speak..just where the pistons are sitting in the cylinders. old says it 'takes what it takes' for the ATF to work.
Once upon a time, I had a JD 430 that was stuck and stuck hard. I finally pulled the head and took a wood block and put it on top of the piston and whacked it with a sledge hammer until it broke loose. I tried everything else I knew and felt I had nothing to lose....it either had to move or come out...in pieces if need be. But, all was well..it broke free. I honed the cylinders a bit, put everything back together and it ran fine. Your mileage may vary.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
