Use a sleeve puller to get the old ones out. Then clean like you say use liquid soap or something to lube the o-rings being carefull not to damage them when installing the new sleeves. The sleeve will fall rite in aws it is not like a dry sleeve as the dry ones are pressed in. Dont be alarmed with the top of the new ones being able to wiggle them some after installing as the head will hold them fast. You will want to get a couple of short cap screws with a washer to hold the new ones in place when installing the pistons and rings as the drag on the new one can move the new sleeve out of the bore. I use a cap screw about 1 1/2 long with a washer to hold the sleeve. You will want to dip the new piston and rings in a container of engine oil before installing in the sleeve and lube the bearing with some assy lube that you can get at any NAPA before fastening to the crankshaft that way you have all the parts lubed good before starting as there is no way to prime the oil pump getting oil to the new parts with the sump in oil it will start pumping oil as soon as the engine turns over.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
