Jesse: Go for scotty's photos, the modifications he has made strenghten the whole setup. My blade is not factory, however until I braced it from the final drives, I was always breaking or bending blade frame. The one that bothered me the most was torque tube. My blade, like the factory blade was braced to the torque tube. One day plowing snow ground froze hard, blade hooked a rock frozen in soil. It sheared the 5/8" bolts fastening blade brace to torque tube. It hit hard enough one set of threads in torque tube will no longer hold a bolt I was in low gear but did have heavy corked ice chains on tractor.
My blade has been modified so it attaches to tractor in 4 places thus spreading out shock load on castings. It hooks to each final drive, with a cross member right under clutch housing, with that cross member bolted to clutch housing, then frame extends on to cultivtor mount just behind front axle. This is a one piece sub frame with blade push arms hinged on the bottom side, just ahead of clutch housing. It looks a wee bit like a bulldozer, but I'll guarentee no one will break blade or tractor. If he does, his ribs will be inverted and shape of steering wheel. Hard frozen ground is a fact of life up here, spring trips just don't cut it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.