Posted by Chipper on August 15, 2007 at 19:55:11 from (207.68.239.252):
Bought a 450 this week and had the bowl off the carb today. Engine is fresh but tractor had pretty much been sitting up for the last 2 years other than the occasional crank and stroll around the lot. It didn't want to seem to open up as much as I thought it should when I got it. It than began to run ruff and flood and then clear up. It would then hang up and stay at one particular rpm reading regardless of where the throttle was. I pulled the bowl off today and everything internally looked pretty clean except the needle would stick just a little in the seat. A light tap would free it. I went ahead and put a new needle and seat in and cleaned the screen on the fuel supply line which was almost stopped up. I put it back together and cranked it but still isn't running right. What's the standard setting on the idle mixture, throttle stop and fuel setting screw? I've also got to check to see if the governor is gummed up anywhere.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
