Posted by chadd on August 14, 2007 at 12:48:01 from (4.188.132.25):
Well, I replaced the intake manifold gaskets, the fuel filter, and the fuel shut-off solenoid. The two front plugs look darker now, so it appears that the front intake gasket was leaking some. However, the engine runs pretty much the same as before. I have done a compression check on it and found the following numbers: Cylinder 1: 149 psi Cylinder 2: 154 psi Cylinder 3: 149 psi Cylinder 4: 155 psi I don't know what the correct value is for compression on a C-153, but they seem decent, as all are within ten percent of each other. I also left the compression tester on each cylinder for about a minute, and none seemed to leak down in that time. I double checked the firing order and plug wiring and each seems correct, as the distributor rotates clockwise. What else could cause it to miss and sputter when revving it up and sound like it is not hitting on all four? Thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
