Farmall & IHC Tractors Discussion Board |
Re: '56 400 LP - How do I fill the tank on a LP? How did th
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by NDS on August 12, 2007 at 08:13:58 from (64.12.116.73):
In Reply to: '56 400 LP - How do I fill the tank on a LP? How did they d posted by 1951rtu on August 12, 2007 at 06:56:45:
The best, safest and quickest way is with pump. The low budjet way and the way we did it is to have LP tank that has a liquid feed from bottom of tank (home LP hookups feed vapor from top of tank) with valve,flex hose and fitting to fit large fitting at top of tractor tank and a fitting to fit smaller fitting on top of tractor tank. You bleed large amount of vapor out through small fitting and this lowers temperatue in tractor tank (sometimes tank will frost over) causing pressure to drop in tractor tank and higher pressure from warm LP in feed tank will cause liquid LP to flow to tractor tank. When you see liquid at vent tank is full, this is wastefull (about 10% loss) and dangerous as escaping LP can easily be ignited have seen vapor drift 100 ft. or so to open flame causing fireball to flash back to tractor. Small bleed cock on tank will not bleed enough vapor to cause temperatue in tractor tank to drop enough to transfer LP from supply tank.
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|