Farmall & IHC Tractors Discussion Board |
240 not charging
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Rob in Ore on August 09, 2007 at 13:08:58 from (198.92.66.112):
This has 6V pos ground. New wiring (although I used the crimp not the solder). The generator, dsitributor, starter have all been checked at a reputable shop. The voltage regulator is the second one in six months. The first one may have been ruined by me when I was getting the charge indicator on the dash to function (switching wires). The battery is also the second one in six months, the dealer replaced the first because it wouldn't take a charge. But now I wonder if the dead regulator also killed the first battery. The battery is dead again. It will start after I charge for an hour or so. I just make sure that I don't shut off the tractor until I get it back in the barn. What should I be looking for? Should I just forget it all and switch to 12 volt? Since I can't afford that, I will just keep recharging the battery. Where does the ignition voltage come from? Direct from the generator? Or from the battery? Could vibration be killing the regulators? I had to build my own bracket, could I have messed that up?
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|