Re: How do you adjust the seat tension?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mike CA on August 08, 2007 at 21:30:39 from (75.31.169.155):
In Reply to: How do you adjust the seat tension? posted by D Slater on August 08, 2007 at 18:33:14:
D Slater said: (quoted from post at 18:33:14 08/08/07) Mike from my early days on a farmall tractor, that was the only kind of seat I knew at the time. That bolt through spring should of had 2 jam nuts on it and they were tightened or loosen to adjust seat and would hold 250 pound. The sping actualy compresses very little before seat bottoms on platform so if you have a little gap between coils it may be enough. As cowman posted the pin and where it passes through pipe gets worn and if so will give a lot of side slop to seat. If very bad I weld a steel bushing thats sized right for pin into pipe, it doesn't show when mounted. If the mounting bracket holes for pin are bad I weld holes and redrill for pin. Also sometimes the spring adjusting bolt will wear into pipe on bottom side. 1-800-234-3280 sells new springs for your seat but cost 39.95 |
Thanks D. Good info.
And thanks to the rest of you as well. I'll tear into the seat when I get the tractor and see what's up.
Replies:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|