Farmall & IHC Tractors Discussion Board |
Re: Hydraulic system diagnosis on a 100 please guys!!!! :)
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Patrick Martin on August 06, 2007 at 23:19:28 from (74.234.92.107):
In Reply to: Re: Hydraulic system diagnosis on a 100 please guys!!!! :) posted by Hugh MacKay on August 05, 2007 at 13:46:02:
Yep that's me Hugh! LOL! I've always been one that has figured if I tear part of it down I might as well do the rest. Wouldn't you know slipped up on this! I should have known better that to have not taken the gear off that shaft when i tore it down. I think I might have thought it was just a bushing and there was no seal.....oh well. I haven't gotten to break into it just yet since I posted this but hopefully tommorrow I can get to it. I think I'll go ahead and replace the O-rings on the lines again too since I have plenty of spare O-rings. It just sucks to have to mess that paint up again. :(
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|