Farmall & IHC Tractors Discussion Board |
Re: F20 oil pressure
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob Kerr on August 04, 2007 at 18:18:45 from (205.188.116.73):
In Reply to: F20 oil pressure posted by David F. Humphrey on August 02, 2007 at 11:59:59:
I was told that 10-20s and Regulars ran 6lbs right out of the box. I have a cousin who rebuilt his Regular and put a aftermarket oil gauge on it and would show pressure so he wouldn't run the tractor for a couple years. I found out about the 6lbs and he bought the right gauge for it and the needle went right up to where it was supposed to run at so now he takes it to shows. The oil pump only lubes the oil troughs for the rod dippers to catch and a line goes to the timing gears/governor area. the rest is slash lubed and there are troughs cast into the block to catch the oil and direct it to the mains and cam bearings. Oil flow is good! no flow is bad! I use straight 30wt or even 40wt if hot out and working hard. I use only detergent oil if the engine has an oil filter. If no filter use non detergent and clean out the pan once a year to get the sludge out and change oil more often.
Replies:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|