Farmall & IHC Tractors Discussion Board |
Re: Farmall B alternator
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on August 04, 2007 at 08:07:48 from (71.87.39.51):
In Reply to: Farmall B alternator posted by Dave H (MI) on August 04, 2007 at 07:50:39:
Well it is great that we are moving in the correct direction. The wire sizes are an issue. The wire from the big alternator stud is the only big one #10. It should go from the big stud directly to the non battery side of the amp meter. That should be a ring terminal on both ends. The wire from the spade terminal should be 14 gauge, and two of them can connect to one terminal with a spade terminal that adds a second male spade (they are at NAPA etc. and help putting two terminals on one spade) JimN
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|