Farmall & IHC Tractors Discussion Board |
Farmall B alternator and ammeter
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave H (MI) on August 01, 2007 at 20:16:05 from (64.12.117.137):
I read the info John T posted for me below. If he or anyone else should read this thread I just want to clarify/summarize some of what I understood. Remember guys, I am about as sharp as the business end of a light bulb when it comes to some of this stuff! First, I need to move the ignition switch wire from the starter side of the ammeter to the alternator side. Next, the plug in the alternator has one wire that goes to the stud on the back of the alternator. I stuck my nose in there and the other wire has been cut off at the plug. Looking back at the day I bought this tractor, I can see that I had a couple of fast ones pulled on me. SO, I need to replace that plug with one that has two wires and the missing wire will run to the hot side of my on/off switch. I will need to solder into that wire the mentioned resistor and also the below mentioned diode. Sound about right? I'll look at Radio Shack for the electronic stuff and hit the auto parts store for the wire harness if that sounds right. Then I will see how much damage I can do. I have not verified that it is a GM 10 SI etc etc alternator, but will look for a plate on it in the AM. Pull hard on the reins if I have it wrong! Thanks guys!
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|