Farmall & IHC Tractors Discussion Board |
Re: timing a H
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by stevex on July 14, 2007 at 14:30:39 from (65.77.69.174):
In Reply to: Re: timing a H posted by stevex on July 14, 2007 at 14:12:23:
The problem is the magneto is out of time with the engine. My fault, but it is out of time. I put a piece of tissue in the #1 plug hole, then cranked till it blew out. The notch was at a right angle (90 degrees) to the top of the pulley. I continued to crank until the notch was at the marker alongside the top of the pulley. I lined up the rotor in the #1 firing position, or as close as I could get eyeing it. put the cap back on and tried to start it. Thats is were I am now. I have repeated the procedure several times with no change. What am I doing wrong or what am I missing.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|