Farmall & IHC Tractors Discussion Board |
Re: Owen Aaland/Tractor Vet
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on July 13, 2007 at 18:05:42 from (75.19.122.16):
In Reply to: Owen Aaland/Tractor Vet posted by Allan In NE on July 13, 2007 at 15:30:43:
Well Allen they realy suppose to be a GROVED TAPPERED pin . Now if things are wore or someone has drilled it stright and installed a roll pin or a ROLLEd pin here is what i have done , I have drilled them out to 1/4 inch and taken a grade 5 bolt and ground the head down to almost paper thin so it will not bind on anything and used a half nut as they are thinner so here again it will not catch on anyhting and it is fixed and ya ain't going to shear it . Also take a center punch and stake the threads so the half nut does not back off.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|