|
Farmall & IHC Tractors Discussion Board |
One quiet H YEAHHHHH!!!!!!!!!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob Kerr on July 07, 2007 at 00:26:18 from (205.188.116.73):
I got it! It was the new front gear! It wan't meshing the teeth all the way like it should. I started off today going 60 mile round trip to pick up the new constant mesh gear and came back home around 3pm and started on the H. Pulled out the main input shaft and put in the spacer that was missing and put it back together, still made noise and may have been worse. After cussing a blue streak (that didn't fix it either) O pulled it back apart againe and put in the used main input shaft from the parts H , seemed quiet when I turned it with a couple bolts in it but when I drove the flange on it got loud again when turning by hand. put a big bar on the flange and pulled the gear back forward and then pulled it out and put the flange on with the big hammer. For some reason it was tight as all heck. Any way then back together and it was nice and quiet to turn by hand so on went the clutch joint with new bolts and retainers and rubber washers and fired it up with the belt pully off to check it out. I had the clutch pushed down and held with a block of wood which slipped and I got the Exon Valdeze treatment. (that would have made a good laundry commercial!) Well anyway it was quiet as a mouse on christmas night. Belt pully went on , gas tank lowered, battery bungied and went for a drive about 2AM. It sounded great and so smooth! If I wasn't so tired I would be doing backflips., but I won't, it is now 3:30 AM and I am hitting the shower to stay in the ol ladys good graces and not destroy the sheets. She took it for a drive around the block too. I think she is hooked!
Replies:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
