Farmall & IHC Tractors Discussion Board |
Re: wiring lights on super c farmall
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by C-Man on July 06, 2007 at 05:10:53 from (69.77.252.108):
In Reply to: wiring lights on super c farmall posted by parisspringstom on July 05, 2007 at 19:02:50:
I just ran 2 wires from the switch. One for each light. I started with a small wire and was lucky enough to get it hooked with a small hook and then I pulled the larger wire through. I was able to put the small wire all the way through the "tube" and then I was able to use a small, but long, o-ring pick to pull it down the "post". Tie the wire you want to use on your lights to the small wire and it should pull around to corner of the "tube" and "post". I tried to take the set screws out of my Super C and they would not move. Good luck.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|