Farmall & IHC Tractors Discussion Board |
Re: O.T. Washing the Farmalls.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob Kerr on July 04, 2007 at 22:53:08 from (64.12.117.8):
In Reply to: Re: O.T. Washing the Farmalls. posted by georgeky on July 04, 2007 at 22:29:46:
Our corn here is funny, some guys got it in early and then the rains hit and delayed the other fields by a couple/3 weeks. We have corn almost going to tassle and some that is chest high. The early planters have some water stressed corn in low spots and the late planters don't seem to have that. If it keeps going like it is with the rain coming once in a while and good sun we should have a bunch of smiles at harvest time around here. I am sure in Owen county where my M is they got over 2 inches today and it is hill country. I just hope my road repair held! Had the creek bypass the culverts, cut through the bank and run down the road washing out a 30 ft long stretch. Had to put rip rap down and #2 on top. That creek upstream from thwe road stays damp most of the summer but a heavy rain will turn it into a white water river quick! down stream it flows slow all year because there is a dandy spring there. I read the post on the other board about the easment problem you have. I know what you mean, The road I am talking about is an easement and a half mile long just to get to the corner of Dads property. The land that the easement goes down has new owners so we are taking things slow and easy with them.
Replies:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|