Farmall & IHC Tractors Discussion Board |
Re: 12v conversion for super a
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by SuperA-Tx on February 16, 2007 at 16:13:58 from (4.90.14.242):
In Reply to: 12v conversion for super a posted by GWINN on February 16, 2007 at 16:00:56:
Bob has the wiring diagram for it on his site. Its image #11. He also has one or two articles on it in the Research Section on the left hand column of the page. If you go back a few messages you will see I been talking (asking actually) about the one wire system. Then if you go back another few (three or four) pages in the posts you will see another topic by me on my one wire Alt. I think you might want to go with the three wire and just do it right to begin with. Your amp meter will work but you will have to switch the wires from whatever post they were on to the other post. http://albums.photo.epson.com/j/AlbumIndex?u=4001561&a=30065733&f=0
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|