Farmall & IHC Tractors Discussion Board |
Re: Cab Swap from 1066 to 706
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by nsmall21 on February 13, 2007 at 12:58:40 from (207.7.178.120):
In Reply to: Cab Swap from 1066 to 706 posted by Carp on February 13, 2007 at 05:34:23:
hello, last year i got a hiniker off a 1466 to put on my 706. i dont know if the floor from a 1066 would fit on a 706, but i didnt get the floor from the donor tractor anyhow. there is about a 6 inch gap the width of the hood under the windshield you will need to fill. on the floor there is a 3 inch gap on either side, in the back this goes out to about 8 inches on both sides. also my batteries were to tall to go under the floor plate, so i got shorter batteries that sit on the original trays, just outside the cab. it sure makes it nicer plowing snow and feeding round bales in weather like we are getting in ne pa right now! i havent been around ih cabs much so im not sure how much different one of them would be to rig up on a 706. nate
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|