|
Farmall & IHC Tractors Discussion Board |
Re: Got the 300u going, but...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JayWalt on February 12, 2007 at 10:09:42 from (70.226.20.153):
In Reply to: Got the 300u going, but... posted by JayWalt on February 11, 2007 at 19:30:32:
well there is no priority valve and/or power steering. All the hoses are plumbed as they were before, and when i first got the tractor when the system was fine. The main reason i took the system apart was to address the filter and because the system seemed to be partially deadheading, not to the point the relief valve kicked in, but enough to labor the engine when both vavles were in neutral. Maybe cause it was so low of temp, around 5degrees F and there was still water in the oil, as some was left in the cylinders when i first changed it. The only thing im not sure of is one of the valve's pistons, i wasnt sure if i had it turned 90degrees. Now if these are open center valve, and u activate one valve, what prevent the fluid from just going through the open center of the other vavles? Shes not constantly deadheaded and it seems to be cycling alot less. today i will finish filling it up and running it a bit and bleeding out the system, if that doesnt remedy it, i will be back for more advice.
I thought thats all the safety regulator did, but i thought i read in a few posts of mine back that the regulator also directed the pressure flow when a valve was activated? whats the third smaller port for then on the side of the res cover where the valves mount.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
