Farmall & IHC Tractors Discussion Board |
Re: still got wiggle room (I know, here we go aga
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by GordoSD on February 11, 2007 at 15:50:20 from (66.115.200.140):
In Reply to: still got wiggle room (I know, here we go again) posted by LA in Wi. on February 11, 2007 at 09:06:30:
Lets think about the dynamics here. The wobble is certainly not starting at the sector/worm gear and traveling down to the wheels. Just the opposite. And wobble has to be set in motion by the tires, then wheels. The rest of the assembly id there to hold everything in status quo. If you had NO gears in there at all the tractor should still, tow, coast without wobble. Of course you couldn't steer it but it shouldn't wobble.By deflating one tire, you are causing a pull to one side, which you are "holding against" with the steering, thereby reducing the wobble, but inducing tension into the system which will wear the gears more. I'd go back down to the wheels and tires, axles, bearings and get that right first. Gordo
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|