Farmall & IHC Tractors Discussion Board |
Calling all F20 experts!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Scott in SC on February 08, 2007 at 10:47:01 from (205.188.116.133):
I’ve got an F20 with a Heisler OD on it. I’ve drained then rear end lube out intending to change it; got about two gallons out, the book says it takes 8. I found the drain and filler plugs, but couldn’t find a plug to determine the correct level. Nebraska Cowman told me the plug is on the front of the tranny between the shafts. That means it is under the OD box. Can anyone give me an approximate measurement down from the top of the tranny to the bottom of the level hole? Is there another way to check of get the correct level? Perhaps measure down from the filler hole to the level? Be gentle, this is my first red tractor;)! Thanks much, Scott in SC
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|