Farmall & IHC Tractors Discussion Board |
snow plow hydraulics question.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Brian in NY on January 31, 2007 at 06:35:03 from (12.149.100.21):
I have a two way cylinder to lift the blade on my snowplow on the H. Of course the H hydraulics are one way. Is there an easy, cheap way to add a return line or even a vent line to allow this two way cylinder to lower my plow blade faster? Right now only one line hooked up and naturally the fluid is flowing back into resevoir through that line. It literally takes 30-45 seconds for the plow to lower when raised 6-8 inches. Gets cold sitting on the tractor waiting for it to drop! Can I just get a one way cylinder? If so...anybody want to trade for this newer two way cylinder? The plow is an ancient Meyer plow, and believe me it is plenty heavy enough to pull down this cylinder if it were operating correctly.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|