Farmall & IHC Tractors Discussion Board |
300u Hydraulic worries...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JayWalt on January 30, 2007 at 11:03:31 from (70.226.20.153):
Let me paint the hydraulic picture for you guys. I have one IH valve hooked to the res on my 300u with no other blocks on it, just the vavle and cover plate, with 1 hose going to my loader lift cylinders. Now I also have another valve, but there is a block between the res and the valve and another block bolted to the bottom of the valve and is where the 2 hoses come out for the hitch. I was plowing snow today and i noticed that the engien seemed to be laboring, but if I use the hydraulics, either valve the engine seems not labored. I thought maybe the valves werent centering but the laboring goes away if i use either valve, actually moreso with the loader lift valve. I'm assuming that because either of the vavles alleviates this problem its not in one of those added on blocks, am I right in the assumiption. The pump also seems to not whine like it normally does and the hydraulic fluid seemed awefully hot, not impossibly to touch the hardlines, but definitely toasty for being 15 degrees outside. Any ideas would be appreciated.
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|