Farmall & IHC Tractors Discussion Board |
Re: priority flow valve
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nat 2 on January 25, 2007 at 11:38:00 from (64.80.110.27):
In Reply to: priority flow valve posted by Hydro on January 25, 2007 at 10:17:08:
A priority valve is DEFINITELY necessary. It needs to be installed between the hydraulic reservoir and the two-way valve. Otherwise, you will have no power steering. Your two-way is "open center" which means that hydraulic fluid flows straight through it and back to the reservoir if it's not operating a cylinder. If you try to run two parallel circuits, one to the two-way, and one to the steering, the hydraulic fluid will take the path of least resistance. In other words, every time the steering motor asks for pressure, the fluid will flow through the two-way valve. Just FYI, but connect the priority flow to the steering. In a fit of absolute brilliance several years back, I told Dad he should hook the priority flow to the two-way valve... BONEHEAD! Didn't notice it until I was trying to steer the two-rake hitch on a very hilly field. It's no fun when you need to turn the tractor and the rake at the same time going down a hill, and the steering locks up!
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|