Farmall & IHC Tractors Discussion Board |
Excessive blowby in D166 engine
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Farmer Bob on January 24, 2007 at 21:02:25 from (71.53.64.77):
My 340D starts and runs fine but after it is warmed up I get a constant drip from the engine breather tube. The engine was completely rebuilt two years ago and it has done it ever since I put it back in the tractor. For some reason, it seems to be building up pressure in the basement and by is inferior design, the breather is located directly above a side drain hole in the side of the block. I've checked the cover plate and ensured the breather media is in place on the inside of the breather tube plate. The tractor has been worked hard, (Plowing a full day pulling a model 192 Roll over plow and feel the rings have seated. What else can I check?
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|