Farmall & IHC Tractors Discussion Board |
Re: M overhaule
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by El Toro on January 23, 2007 at 14:12:20 from (152.163.100.65):
In Reply to: M overhaule posted by james braley on January 23, 2007 at 13:18:05:
I would agree with Old on tearing the engine down. You need to measure the crankshaft or have it measured at your local auto machine shop. To be sure you are going to have good oil pressure you need close tolerances on the rod and main bearings. The same on cam bearings. Those sleeves need to be measured too. If they worn beyond the wear limit I would install a new sleeve kit. Check that oil pump for wear too. You don't want to have to pull that engine apart the second time. Hal
Replies:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|