Farmall & IHC Tractors Discussion Board |
Re: How much does a Regular's engine weigh?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on January 12, 2007 at 06:49:07 from (204.249.178.32):
In Reply to: How much does a Regular's engine weigh? posted by Ludwig on January 12, 2007 at 06:38:27:
I think my hoist has a 1400 lb rating as a minimum. Slide in the lift arm and it goes up to 2250, then 4000. I think 1400 is sufficent, provided you are not trying to lift the whole front end including the front bolster off the ground. I would guess the engine weighs 6-800 lbs, I could be way off. You can remove the head first to lighten the load. If you are going to repair it yourself, out of the tractor, you also need an engine stand -- there it gets a little tricky, as there are big differences in them. More important than the entire weight you are trying to lift is the stability of the hoist/stand you are using. They will tip over.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|