Farmall & IHC Tractors Discussion Board |
Re: INTERNATIONAL 384 INJECTOR PUMP
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Fromjb2 on January 09, 2007 at 18:53:27 from (74.101.67.211):
In Reply to: Re: INTERNATIONAL 384 INJECTOR PUMP posted by Fromjb2 on January 09, 2007 at 18:51:59:
4)Loosen all the injector lines and the fuel lines but do not completely remove yet. 5)Remove the front timing cover on the fan side and mark everything as well. There should be 3 cap screws thru the timing gear that screw into the drive hub on the pump, remove them. 6)Remove the 3 nuts and washers that hold the pump to the rear of the timing cover. 7)With a friend holding the pump firmly remove the injector and fuel lines. 8)The pump should pull out of the cam drive gear. 9)Mark location of drive hub to pump body. 10)Seal all holes and fuel lines to prevent dust and dirt contamination. 10)Do not turn engine over with pump removed.
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|