Farmall & IHC Tractors Discussion Board |
Re: 263 gas -can i bore to 282 gas pistons?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nat 2 on January 03, 2007 at 05:32:22 from (64.80.110.27):
In Reply to: 263 gas -can i bore to 282 gas pistons? posted by bryan schroeder on January 02, 2007 at 19:56:49:
As far as I know, the blocks for the 263, 282, 291, and 301 gas engines are all the same. The only difference is the diameter of the holes. Yes, it's a lot to bore out, but the engine was designed such that it could be done, and was done tens of thousands of times by IH, as this engine block design was installed in 560, 656, 706, 806, 756, 856, 666 and 766 gas tractors as 263, 291, and 301 cubic inch versions. If you can re-use the 282 pistions (dunno about the wisdom in that), the block could still be re-bored for 291 sleeves in the future, and may be able to accept 263 sleeves without being re-bored at all, as I seem to recall that the 282 was simply a 263 with the sleeves removed.
Replies:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|