Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: JayWalt Don't give up


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by JayWalt on January 02, 2007 at 16:30:37 from (24.223.138.48):

In Reply to: JayWalt Don't give up posted by Janicholson on January 02, 2007 at 15:28:28:

Thanks man.
I will probably try those things tomorrow. It is supposed to be nice the next couple of days, so I dunno, I might be running my R/C all day. I will defintely check the reg ground. It does have the ground strap from the regulator to the mount, because its rubber mounted. The mount iitself might be the culprit.
On a side note, I'm doing pretty well. My car ha been leaking oil between the engine and tranny, tall tell sign of a bad rear main seal. It's an 89 grand prix. I've replaced them without pulling the motor before, So I was gonna try it on this engine. Well since It's a v6, the exhaust pipe beteen the 2 manifolds needs to come off, but I cant because the studs wont come out , and It would be a major
PITA to pull off the front manifold as there is alot of crap in the way of it. I got to looking around and seen alot of oil on the top. I was like what the heck. Well my car has coilpacks, but the block still has a distributor dummy shaft to run the oil pump. Well looky there, when I run the engine, oil nearly shoots out from it. The seal is bad!! Hopefully it lowers my quart a week oil hog of a car. It sure has to help. The oring was flat as a pancake. Just got the parts, time to put her back together. So if this works, then I dont have a main seal problem, which is AWESOME!! So needless to say, let the tractor battery charge for now, I'll work on her later. My car does 55 and has a heater, the tractor doesnt =)



Replies:




Add a Reply

:
:
: :

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy