Farmall & IHC Tractors Discussion Board |
Re: brake disk clearance
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jmh54738 on December 31, 2006 at 02:04:50 from (199.86.19.63):
In Reply to: Re: brake disk clearance posted by CNKS on December 27, 2006 at 17:13:20:
I"ve machined a lot of brake parts for the local IH dealer. He wanted the assembled brake components to be 1/32 inch lower than the edge of the drum. Also he had me turn down 560 discs to fit the smaller tractors as he said the brake disc material was no good in the smaller discs (the spline was the same size. I turned off about an inch and it stinks...not good for the lungs. John
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|