Farmall & IHC Tractors Discussion Board |
H gas head
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by sgtbull on December 28, 2006 at 19:13:07 from (65.73.245.171):
I recently rebuilt a 1940 H, and replaced the distillate head w/ a gas head. The three tubes which are pressed into the head, through which center studs pass, were all but rusted away. I purchased three new sleeves from Case/IH, at about $30 each, but they were oversize.....wasn't anyway in the world they were gonna fit...I was annoyed, and trying to get the engine together in time for a show, so I turned the sleeves down on my lathe and pressed them in....seemed like a lot of trouble and I really thought they should have fit right the first time. The part # seemed to match up w/ what the original parts book called for, but what gives? Anyone else ever experience that? Or did I somehow get the wrong sleeves?
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|