Farmall & IHC Tractors Discussion Board |
Super A adjustable front end
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mark in Wa on December 18, 2006 at 04:54:46 from (131.35.138.10):
My super A has the adjustable front end but the pin holes on the outer portion seem to be elongated in several of the inner positions. what have others out there done to restore this to the proper strait up and down position. I do not like it when the vertical part of the spindle pitchs back and am concerned about doing more damage to the front end. I thought of welding the holes, grinding and redrilling but I believe these are cast and that is hard enough to weld without the additional stress, my second thought is to run a bushing completely through the thing. Any help would be much appreciated. I guess whoever has this tractor in the past drove it like they were in NASCAR, not real good for the equipment.
Replies:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|