Farmall & IHC Tractors Discussion Board |
Re: No low end torque
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by vally farm on December 16, 2006 at 08:45:12 from (207.69.138.136):
In Reply to: No low end torque posted by North Dakota H puller on December 16, 2006 at 07:18:01:
I "built" a little 2.3 ford in a fox body Mustang, to prove how much power it can make. She ran pretty strong until I put in a higher profile cam. Ran like a jet engine above 5000 rpm's, but couldn't hardley move until it could get to those rpm's. My guess would be the cam grind. Try a 305 cam and I think you'll be much happier. Just a thought, My neibour had a H and said it couldn't pull his spreader for dirt. I bought a Super H, and it can almost pull as much as Pop's Oliver 1600 with a moter job. 1/3 the fuel too. Mike
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|