Farmall & IHC Tractors Discussion Board |
Re: Ways to pull sleeves without taking the crank
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Lunatic Fringe on December 12, 2006 at 11:23:46 from (63.218.43.2):
In Reply to: Re: Ways to pull sleeves without taking the crank posted by RustyFarmall on December 11, 2006 at 09:05:22:
Rusty, It is possible to change the main bearings without removing the crank. I did that on the first engine I did an rebuild on. That was on an M, maybe an H is different. On my H, I had a non-running tractor with a cracked block so I had to tear everything down anyway. I didn't pay attention to see if you could have taken the mains out without the crank. Both engines run good but the one that was totally rebuilt with crank turned and block line-bored runs better.
Replies:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|